News

What is the operating method of the ice maker?

Update:03-09-2020
Summary:

What is the operating method of the ice maker? 1. Ice m […]

What is the operating method of the ice maker?

1. Ice making operation process

⑴Before starting up, you must check whether the automatic water supply device is normal and whether the water tank storage is reasonable (the water level has been adjusted to the correct level when the machine leaves the factory, and the user does not need to adjust it).
⑵Plug in the power supply and the ice maker starts to work. First, the water pump starts to run (the pump has a short-time air discharge process) after about 2 minutes, the compressor starts to start, and the machine enters the ice making state.
⑶When the thickness of the ice cube reaches the set thickness, the ice plate probe starts to start, the defrost solenoid valve starts to work, the water pump stops working, the hot air enters the evaporator, and the ice cube falls in about 1 minute. When the ice cube is falling, turn the falling ice baffle over and open the magnetic reed switch. When the reed switch is closed again, the machine enters the ice making process again.
⑷The compressor will not stop during the entire ice making and deicing process.
⑸When the ice storage bin is full and the magnetic reed switch cannot be closed automatically, the machine will automatically stop working. When enough ice is removed, the magnetic switch will be closed again, the machine will start after a delay of 3 minutes, and the ice making process will be re-entered.

2. Adjust the thickness of the ice bridge

⑴The thickness of the ice bridge should be about 3mm. The distance between the probe and the evaporator should be about 1.5mm thicker than the actual ice bridge. Turn the adjustment screw clockwise to increase the thickness of the ice bridge. Change 1.5mm).
⑵ Check the wiring and connection bracket of the ice plate probe, and ensure that it can rotate freely so that it can return to the correct position after each ice making process.

https://www.mxhuge.com/wp-content/uploads/2019/12/17-1.png

0
Views: 344