Maintenance Of Ice Machine

Cleaning and maintenance: The content of the maintenance cycle should not exceed 15 days. Air filter cleaning. Soak the filter in a neutral detergent solution, clean it with a soft brush, and install after drying. No more than three months for surface cleaning. Use a cloth dipped in neutral detergent to wipe the water. Clean the system according to the relevant instructions in the "Cleaning Operation Procedure". Disassemble the water system components for no more than six months for cleaning and disinfection; cleaning and disinfecting the refrigerator "Operation procedures for removing parts for cleaning (or disinfecting)" instructions for condenser cleaning. dust, compressed air can be used to blow from the top to the bottom; for oil, you can use a commercial coil cleaner to clean. Check whether the circuit wiring is loose, tighten or plug in the wiring
1. Cleaning procedure
1.1 When the ice harvesting process is over and the ice cubes fall off from the evaporation tray, turn the function switch to the "stop" position;
1.2 Take out the ice cubes in the refrigerator;
1.3 Turn the switch to the "cleaning" position to start the cleaning or disinfection process, and water starts to pour into the sink.
1.4 When the water pump is running, the water flows out from the water distribution pipe, and after flowing through the evaporation pan, add an appropriate amount of detergent to the water tank.
1.5 The ice maker automatically completes the cleaning process and automatically rinses the machine.
1.6 After the cleaning is completed, the ice maker enters the standby state. At this time, turn the function off to the "ice making" position, and the ice maker will start making ice.
2. Operating procedures for removing parts for cleaning (or disinfection):
2.1 Turn off the water source of the ice maker and cut off the power supply of the ice maker;
2.2 Remove the parts that need to be cleaned (or disinfected) such as the water curtain plate and the water distribution pipe;
2.3 Soak the removed parts in an appropriate amount of cleaning (or disinfecting) solution. The ratio of the solution is shown in the following table: Solution category Water cleaning/disinfectant dosage cleaning solution 1 gallon (4 liters) 16 ounces (500 ml) disinfectant solution 4 gallons (15 liters) 3 ounces (90 ml)
2.4 Clean the parts carefully with soft bristle brush or sponge (not metal brush);
2.5 Use solution and brush to clean the top, side and bottom of the evaporator projecting part;
2.6 Thoroughly rinse all cleaned (or disinfected) parts with clean water; 2.7 Install and remove parts; 2.8 Turn on the water source and power supply.
3. Notes for cleaning (or disinfection):
3.1 When using ice machine cleaners and disinfectants, please wear rubber gloves and goggles. It is recommended to wear a face shield;
3.2 Only detergents and disinfectants are allowed; the part number of the detergent is 9405463, and the color is blue; the part number of the disinfectant is 9405653, and the color is pink. Please provide the part number when ordering;
3.4 Cleaning and disinfection should be carried out separately, first cleaning and then disinfecting. Do not mix cleaning agents and disinfectants;
3.5 After adding the cleaning agent or disinfectant, the cleaning (or disinfecting) process should not be manually interrupted, otherwise there will be cleaning agent or disinfectant remaining in the machine.